Plywood Dryer Veneer-manufacture,factory,supplier from China

The demand for wood veneer dryer is increasing year by year,and it has been recognized and purchased by consumers.Traditional natural air-dried wood is prone to problems such as deformation and cracking.The use of wood dryer equipment can effectively solve this problem.The cost of dryer equipment is high, so basic maintenance needs to be done in the later use process,such as the ground,ventilation system, gate,instrument,heating system and debugging system,etc.The specific operations are as follows:1.The floor of the wood dryer equipment should be kept clean and tidy,and the debris should be c

Veneer dryer is one of the main equipment in the production process of veneer and plywood, and the drying quality of veneer directly affects the quality of veneer and plywood products. The principle is that the veneer is preheated and dried under the clamping of the upper and lower two coils, and the coil is heated by steam or heat conduction oil to transfer the temperature to the veneer.

The four deck veneer dryer purchased by myanmar factory is used to dry rubber wood. The customer gives good feedback. It is used with the biomass burner.The biomass burner which as the heat source can provide high temperature to the dryer to make sure the sufficient heat impinged on the wet veneer in an efficient manner. At the same time, the tree bark from debarker and waste veneer from peeling lathe were burned as the fuel directly, which solved the waste accumulation in the veneer plywood making factory.

There are two traditional heat sources for the veneer dryer, namely, steam boiler and thermal oil heater. The advantages using these two heat sources are one machine can provide heat for more than one veneer dryer. Typically, in a large plywood plant, one big capacity steam boiler or thermal oil heater can supply sufficient heat to several veneer dryers, hot press machines, etc. Only one heat source or heat energy center is enough. The disadvantage is the operation cost will be very high like the fuel cost.

Recently, a brand new veneer dryer from our company is being sent to the customer's factory. After many inspections, the customer finally chose us. We specially customize the production according to the customer's veneer size to ensure that the output of the veneer dryer meets the customer's production needs. It can be used to dry various wood species.

Roller Veneer Dryer is one of the most often used veneer dryers for drying core veneer in the plywood making process. After peeling, the fresh veneer is fed into the core veneer dryer. Through the press of the upper rollers and heating of the hot air sections, veneer is delivered to the cooling section and finally discharged at the outfeed of the veneer dryer. The veneer after drying has uniform moisture content and it is flat without buckle or end waviness.

We are pleased to announce that the double-layer veneer dryer recently customized for a Thai customer has been completed and is being prepared for shipment.

1. The veneer dryer has the relevant data (understood from the product description) in terms of the performance of the humidifier, especially in terms of the use of voltage standards and starting interval provisions, after starting for at least 3 minutes, the humidifier should not be started and stopped frequently, otherwise it is easy to damage the compressor; 2.

Five containers of vertical veneer dryer machines were loaded into the container and ship to the Myanmar.  They were expected to be arrived in the customer's factory and start the installation. Friends who are interested in the vertical veneer dryers, please feel free to contact me for the site visiting.  

Due to various reasons, our engineers were unable to install it on site. This 32-meter double-layer veneer dryer was installed by our Russian customers under our guidance.