thermal oil veneer dryer-manufacture,factory,supplier from China

The demand for wood veneer dryer is increasing year by year,and it has been recognized and purchased by consumers.Traditional natural air-dried wood is prone to problems such as deformation and cracking.The use of wood dryer equipment can effectively solve this problem.The cost of dryer equipment is high, so basic maintenance needs to be done in the later use process,such as the ground,ventilation system, gate,instrument,heating system and debugging system,etc.The specific operations are as follows:1.The floor of the wood dryer equipment should be kept clean and tidy,and the debris should be c

Great news that the four deck roller veneer dryer starts the installation with our engineer's arrival and guidance. Our romania customer arranges 6-10 workers to help install this dryer heate by the thermal oil. 

Recently, several of our customers visited the factory and were very satisfied with our equipment.One of them decided to buy our veneer dryer on the spot after the inspection and signed a contract. We are very grateful to our customers for their trust and recognition. Our equipment biomass burner can directly burn all kinds of waste wood, has the main characteristics of environmental protection, high efficiency and fuel saving, compared with steam or thermal oil furnace dryer, drying cost is greatly reduced.

Great news that shine veneer roller dryer heated with thermal fluid finished installation and is ready for the commissioning. 2 Deck veneer roller dryer with working width 3750mm, 11 sections(4meters one section). Veneer drying capacity 80m3 per day. You are welcome to contact us for the site visiting.      

The 2nd set veneer roller dryer ordered by the customer in Yunnan started the test running. The veneer dryer is heated with thermal oil. The wood specie is birch. Drying capacity is 70-80 CBM per day.  

The 2 deck roller veneer dryer working width 3750mm heated with thermal oil.  This first shipment will be trucked to the customer's factory tomorrow on April 7th, 2023.

Through one month production of veneer drying machine heated by thermal oil, our factory has finished the roller veneer dryer and waiting for the booking.  

First, the heating speed is fast. Microwave heating of veneer dryer is completely different from traditional heating. This is the process by which the heated material itself becomes a heater with no heat conduction. Therefore, although it is a material with poor thermal conductivity, it can also reach heating temperature in a very short time.Two, energy saving and high efficiency.

Core veneer dryer principle is the core veneer in the upper and lower two pieces of coiler under the clamping preheating drying, coiler through the steam or heat conduction oil heating to transfer the temperature to the core veneer, high temperature coiler and wet core veneer direct contact, high thermal efficiency, heat loss is small, the core veneer is heated uniformly, the wood shrinkage of the benign physical process of evaporation, so the core veneer after drying the moisture content of the uniformity of the wood, the wood colour and lustre, inside and outside of the same, will not produc

Xishuangbanna clients to buy 58 meters 4.5 meters wide double roller veneer dryer,heat conduction oil heating,high yield,uniform drying the moisture content of veneer,the customer has now been put into use,satisfied with our equipment,our equipment sure got a lot of customers at home and abroad,we must strive to do better,Welcome customers to visit our factory at any time.